SATEC ETC2002 - Manual (Page 20)

Chapter 4 Connecting to the ETC2002 Using HyperTerminal
20 ETC2002 Network Communicator
Chapter 4 Connecting to the ETC2002
Using HyperTerminal
Windows HyperTerminal allows you to configure the network,
communications and security settings in your ETC2002, and to view certain
diagnostic information such as device diagnostics and network statistics.
HyperTerminal is also used for servicing the ETC2002 and upgrading the
device firmware.
Running HyperTerminal
1. Connect your PC to the ETC2002 COM3 RS-232 port
using the standard RS-232 DTE-DTE (null-modem) cable
that came with your ETC2002.
2. Run HyperTerminal from the Windows Start -> Programs
-> Accessories -> Communications menu.
3. Type a name for your new connection and click OK.
4. In the “Connect Using” box, select the PC COM port to
which your ETC2002 is connected and click OK.
5. Select 19200 bps in the “Bits per second” box, select
“Xon/Xoff” in the “Flow control box”, and then click OK.