SATEC ETC2002 - Manual (Page 43)

Chapter 5 Setting Up the ETC2002 Configuring Device Routing Table
ETC2002 Network Communicator 43
Configuring Device Routing Table
Using PAS
To enter the Setup dialog, select the ETC2002 site from the list box on the
PAS toolbar, select ETC2002 Setup from the Meter Setup menu, and then
click on the Device Routing Table tab.
The routing table allows you to specify a routing path and the shared device
access rules for every slave device connected to the ETC2002. Note that the
Ethernet devices can only be accessed via the routing table.
See Routing Messages over Slave Networks in Chapter 3 for information on
using the routing table in the ETC2002. See Shared Device Access in
Chapter 3 for information on shared device accesses.
The following table lists available routing options.
Label Options Default Description
Gateway Port Ethernet,
COM4, COM5
COM4 The ETC2002 port to
which the device-
addressed messages
will be routed
Device IP
Address
192.168.0.203 The Ethernet device
IP address
Shared Device
Access Rules None – no access limitations,
#1 – PM296 family (PM296,
PM171, PM172)
#2 – SA300 family (SA300,
PM174, PM175, EM610,
BFM136) None Specifies the device-
sharing policy for
simultaneous client
accesses
When selecting the device-sharing policy, select the appropriate rules
corresponding to the device family. In this case, the critical device registers
will be protected from simultaneous accesses.