Barco R9001769 - Manual (Page 17)

5-3
Connections
5976069 BARCOREALITY 6400 14032000
Select with or
then <ENTER>
<EXIT> to return.
S DI SDO S-VIDEO VIDEO
C OM PUTER
IEE E 1394 TRIG M
MONITOR R G B H/C V
5 6
2 1
4 3
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
INSTALLATION
INPUT SLOTS
800 PERIPHIRAL
CONFIGURATION
OSD COLOR
INPUT SLOTS
SLOT SELECTOR [Automatic]
x 1. RGB [HS&VS]
- 2. RGB [HS&VS]
x 3. VIDEO
- 4. S-VIDEO
- 5. DIGITAL INPUT
- 6. IEEE 1394
Select with or
<ENTER> to toggle
<EXIT> to return.
5-cable Input Slot (slot 1)
Slot 1 has 5 BNC input terminals.
The following signals can be connected to these BNC connectors :
Connector name R G B H V
Input signal
RGBHV R G B H V
RGBS R G B S -
RGsB R Gs B - -
Composite Video - Video - - -
Super Video - Y - - C
Component Video - SS R-Y Y B-Y S -
Component Video - SOY R-Y Y s B-Y - -
Slot 1 selection :
Key in 1 on the RCU or the local keypad.
Configuration of the 5-cable input :
The configuration has to be done on the 'Input slot' menu.
To change the signal format :
1 Press ADJUST or ENTER key to start up the Adjustment
mode.
2 Push the cursor key é or ê to select Installation
3 Press ENTER.
4 Press the cursor key é or ê to select 'Input Slots'
5 Press ENTER. The internal system will scan the inputs and
displays the result in the 'Input Slots' menu.
6 Push the cursor key é or ê to select the first slot.
7 Press ENTER key to toggle the input signal priority.
Possible indication :
RGB [HS&VS] = RGB analog signals, separate sync
is horizontal and vertical sync.
RGB CS = RGB analog signals, separate sync is composite sync.
RGB CV = RGB analog signals, separate sync is composite video
or tri-level sync.
RGB-SOG = RGB analog signals, sync on green is composite sync.
COMPONENT VIDEO - CS = separate sync is composite sync.
COMPONENT VIDEO = component video with composite sync on
Y or composite tri-level sync on Y.
VIDEO
S-VIDEO
When using an RCVDS 05 with a 5 cable output module, connect
these 5 cables to this 5-cable input slot (slot1) of the projector.
All sources of the RCVDS can now be accepted by the projector.
Audio connection :
Connect the audio input to one of the 3 audio inputs.
See 'audio configuration' in this chapter for more explanation.
Use of a RCVDS05 or VS05 :
When using a RCVDS05, it is recommended to use a 5-cable output module in the RCVDS. The outputs of this module have to be connected
to the 5 cable input (slot 1) of the projector.
To switch the projector in the 5-cable mode see chapter 'Installation mode'.