Barco R9001769 - Manual (Page 47)

Service Mode
11-2 5976069 BARCOREALITY 6400 21082000
UNIFORMITY
A D J U S T
PURITY
DEFAULT
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DIMMING
MORE...
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
BARCO LOGO
PANEL ADJUSTMENTS
UNIFORMITY
PRESET INPUT BALANCE
I2C DIAGNOSIS
MORE...
Select with or
then <ENTER>
<EXIT> to return.
BARCO LOGO
STATUS : [ON]
BACKGROUND : [ON]
SHIFT
HOT KEY : [TEXT]
Select with or
<ENTER> to toggle/select
<EXIT> to return.
I2C DIAGNOSIS
D C A
DECODER 12H # # #
INPUT SELECT 16H # # #
AUDIO 18H # # #
MOTOR DRIVER 74H # # #
LAMP DRIVER 78H # # #
LCD DRIVER C0H # # #
LCD DRIVER C4H # # #
LCD DRIVER C8H # # #
LCD DRIVER CCH # # #
PANEL ADJUSTMENT
Select the
color temperature
PROJECTOR WHITE
6500
Select with or
then <ENTER>
<EXIT> to return.
PRESET INPUT BALANCE
WHITE BALANCE
BLACK BALANCE
DEFAULT
Select with or
then press ENTER
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DIMMING
MORE...
Select with or
then <ENTER>
<EXIT> to return.
- software version
- Proj. Address : to change the address of the projector, see Change
Projector Address in this chapter.
- Installation : possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration follow the instructions in
chapter Installation Set Up.
- Baud rate : transfer speed for communication with an IBM PC (or
compatible) or MAC. The baud rate of the projector must be the same
as the baud rate of the connected computer. When there is a
difference, consult 'Change Baudrate PC' in this chapter.
- Projector Run Time : gives the total run time since the first start up.
All projectors leave the factory with a run time of approximately 24
hours.
- Projector Serial number : indicates the fabrication number of the
projector. This number can be useful when calling for technical
assistance.
Identification
To display the Identification screen:
1 Push the cursor key é or ê to highlight 'Identification'.
2 Press ENTER to display the Identification screen.
The Identification screen gives an overview of :
- type of projector
- projector address
- software version
- installation configuration
- baud rate
- text ON
- projector serial number
- projector run time
- type of projector : BARCOREALITY 6400