Barco R9001769 - Manual (Page 18)

5-4
Connections
5976069 BARCOREALITY 6400 14032000
S DI S DO S -V IDE O V ID E O
C OM PU TER
IEE E 1394 TRIG M OUSE
M ONITOR
RS232 IN R S232 OUT
A UDIO IN AUD IO IN A UD IO IN AUD IO IN
C OM M. PO R T
R C
C B A R G B H/C V
5 6
2 1
4 3
T V tu n e r, e .g .
M a rc o P o lo V C R
C o m p o s ite
V id e o
or
o r
A, B or C
Computer input/Monitor output
Connect the output of the graphical card of the computer to the Computer input of the projector (connection < 60 cm) or insert an interface
between the output of the computer and the input of the projector.
Connect the monitor of the computer to the monitor output of the projector.
This monitor output is only available when the computer input is used as input.
SDI SDO S-V IDEO VIDEO
COM PUTER
IEEE 1394 TRIG M OUSE
M ONITO R
RS232 IN RS232 O UT
AUDIO IN AUDIO IN AUDIO IN AUDIO IN
COM M. PORT
RC
C B A R G B H/C V
5 6
2 1
4 3
Pin configuration of the D15 connector :
1 RED
2 GREEN
3 BLUE
4 loop through to monitor
5 ground
6 ground
7 ground
8 ground
Slot 2 selection :
Key in 2 on the RCU or the local keypad.
Video Input
Input signal :
Composite video signals from a VCR, OFF air signal decoder, etc...
1 x BNC or cinch 1.0Vpp ± 3 dB
No loop through.
Slot 3 Selection :
Key in 3 on the RCU or the local keypad.
9 loop through to monitor
10 ground
11 loop through to monitor
12 loop through to monitor
13 horizontal/composite sync
14 vertical sync
15 loop through to monitor