Weidmuller PT 100/4 signal conditioners for current output User Manual
Page 2
20
1
General instructions
The WAVESERIES signal conditioner PT 100 should only be in-
stalled by qualified staff. The signal conditioner PT 100 should
only be powered up following professional installation.
2
Application
The W AVESERIES signal conditioner PT 100 can be used to
connect PT 100 sensors as well as converting temperature data
into standard linear curr ent signals. The temperature range can be
set by DIP switches on the printed circuit boar d.
The signal conditioner PT 100/4 can be connected to 2-, 3- and
4-wir e temperature sensors.
3
Mounting and dismounting
Warning!!
Mounting and dismounting may only be carried out
when the power supply has be disconnected. Failure
to observe will lead to considerable damage!
3.1 Mounting onto TS 35 DIN rails
(Figure 1)