Weidmuller PT 100/4 signal conditioners for current output User Manual
Page 3
Advertising
21
3.2 Pluggable electronic components for range alteration
(depending on model)
(Figure 2)
1.
Remove connector , (depending on model either screw -type
or tension clamp).
2.
Press locking clips on both sides of the enclosure.
3.
Pull out the circuit boar d.
Warning!!
The circuit boar d can only be inserted in one position.
The connectors have been coded by the manufactur -
er, ensuring that they cannot be reversed.
3.3 Setting the potentiometer (depending on model)
(Figure 3)
The module has been exactly calibrated by the manufacturer.
Should nevertheless a follow-up adjustment be necessary, open
the hinged cover upwards.
The potentiometers are on the front panel.
Advertising