Rockwell Automation 20P PowerFlex DC Drive - Frame B SCR Modules - Manual (Page 3)

PowerFlex® DC Drive - Frame B SCR Modules 3
Step 2: Remove the Power
Wiring 1. Remove the screws and washers that secure the plastic shields to the
bottom of the drive and remove the shields.
2. Remove the bolts, washers and wiring from the power terminals ( U, V,
W, C and D).
Step 3: Remove the
Protective Covers 1. Disconnect the DPI cable from the HIM assembly (if present).
2. Loosen, but do not remove, the screws that secure the bottom cover to
the drive, then slide the cover down and off the drive chassis.
Remove screws and shield Remove screws and shield
U Phase V Phase
Remove bolts and wiring
Bottom View of Drive
W Phase D C
=
Disconnect
DPI cable
Tightening torque:
1.5 N•m (13.3 lb•in)