Rockwell Automation 1336T FORCE to PowerFlex 700S Phase II Drive Conversion Guide - Manual (Page 19)

1336 FORCE™ To PowerFlex® 700S Phase II AC Drive Conversion Guide
19
Frame G Power Terminal Block
Frame H Power Terminal Block
R
(L1)
S
(L2)
T
(L3)
R
S
T
To Motor
Required
Input Fusing
AC Input Line
typical terminal layout
(located at top of drive)
W
(M3)
U
(M1)
V
(M2) Required Branch
Circuit Disconnect
Connect the -DC Brake
to the -Bus to the drive.
Brake terminals are located on the
DC choke behind the "U" terminal.
Access the DC Choke from
the right side of the chassis.
Connect the +DC Brake
to the +Bus to the drive.
Refer to the Troubleshooting
Guide for information on
accessing the DC Bus Inductor.
380-480V, 224-448 kW (300-600 HP)
500-600V, 187-485 kW (250-650 HP)
R
(L1)
S
(L2)
T
(L3)
To Motor
Required
Input Fusing
AC Input Line
W
(M3)
U
(M1)
V
(M2) Required Branch
Circuit Disconnect
Connect the -DC Brake
to the -Bus to the drive.
Connect the +DC Brake
to the +Bus to the drive.
Connect the DC Brake to the
Link Choke at the bottom of Bay 2.
Front View
380-480V, 522-597 kW (700-800 HP)
500-600V, 522-597 kW (700-800 HP)