Rockwell Automation 1336T FORCE to PowerFlex 700S Phase II Drive Conversion Guide - Manual (Page 40)

1336 FORCE™ To PowerFlex® 700S Phase II AC Drive Conversion Guide
40
Minimum Mounting Clearances
1336 FORCE All Frames
Important: F & G Frame drives require a minimum of 152.4 mm (6.0 in.) between the drive back and mounting wall, if
drives are mounted with sides touching another device or wall. A minimum of 76.2 mm (3.0 in.) is required on
the sides if the back of the drive is mounted against a wall or other device.
PowerFlex 700S
Frames 1-6
152.4mm
(6.0 in.)
101.6mm (4.0 in.)
152.4mm
(6.0 in.)
101.6mm
(4.0 in.)
101.6mm
(4.0 in.)
50.8mm (2.0 in.)
50.8mm (2.0 in.) 101.6mm
(4.0 in.)
101.6mm
(4.0 in.)
With Top Adhesive Label
No Top Adhesive Label