Rockwell Automation 284D ArmorStart - Getting Started - Manual (Page 20)

20
Publication 284D-QS001D-EN-P - July 2006
Figure 13 Jumper Removal
LED Status Indication The LED Status Indication provides 4 status LEDs and a Reset button. The
LEDs provide status indication for the following:
• POWER LED
The LED is illuminated solid green when control power is present and
with the proper polarity
• RUN LED
This LED is illuminated solid green when a start command and control
power are present
• NETWORK LED
This bi-color (red/green) LED indicates the status of the
communication link
• FAULT LED
Indicates Controller Fault (trip) condition
The “Reset Button” as a local trip reset.
ATTENTION
!
Do not remove this jumper if the unit is equipped with an
EMI filter installed.
Remove Jumper