Rockwell Automation 1203-SM1 SLC to SCANport Communication Module - Manual (Page 19)

Chapter
3
Publication 1203–5.9 –– October 1996
Using Basic Mode
Chapter 3 covers the following information:
•
a description of what basic mode provides
•
how to configure the SLC to SCANport module for basic mode
•
how to transfer data
Basic mode sends a 16–bit logic command and a 16–bit analog
reference from the module to each SCANport device. It receives a
16–bit logic status and a 16–bit analog feedback signal from each
connected SCANport device.
INPUT OUTPUT SCANport
Channel 1
Channel 2
Channel 3
CHANNEL 1 CHANNEL 2 CHANNEL 3
SLC 5/01 CPU
PC RUN
CPU Fault
FORCED I/O
BATTERY LOW POWER
0 8
1 9
2 10
3 11
7 15
6 14
5 13
4 12
0 8
1 9
2 10
3 11
7 15
6 14
5 13
4 12
16-bit logic command
16-bit analog reference
16-bit logic status
16-bit analog feedback
16-bit logic command
16-bit analog reference (not used by SMC)
16-bit logic status
16-bit analog feedback
16-bit logic command
16-bit analog reference
16-bit logic status
16-bit analog feedback
1305
1336
SMC
To configure the SLC to SCANport module for basic mode using the
Advanced Programming Software (APS), you need to:
1. Create a file.
2. Enter a file name. For example purposes, we are using SM1_AP
as the file name.
3. Highlight the processor as shown in Figure 3.1.
Chapter Objectives
What Does Basic Mode
Provide?
Configuring the SLC to
SCANport Module for
Basic Mode