Rockwell Automation 1203-SM1 SLC to SCANport Communication Module - Manual (Page 81)

SCANport Messaging B–15
Publication 1203–5.9 –– October 1996
Set Default Parameter Values
The Set Default Parameter Values message lets you reset the values
of all parameters to the factory default values. The following is an
example of this request:
Service=Reset All to Factory Defaults
Parameter Class
Instance
Attribute
Data Length=0 Bytes
M0:e.000
M0:e.001
M0:e.002
M0:e.003
M0:e.004
0005
000f
0000
0000
0000
Value
Set Default Parameter Values
Service=Reset All to Factory Defaults
Parameter Class
Instance
Attribute
Data Length=0 Bytes
M1:e.100
M1:e.101
M1:e.102
M1:e.103
M1:e.104
0005
000f
0000
0000
0000
Value
Response
Figure B.9 shows a Set Default Parameter Values request. This
message has set all parameter values in the SCANport device’s
EEPROM and RAM to the factory default values.
Figure B.9
Example of Set Default Parameter Values
address 0 1 2 3 4 5 6 7 8 9
N10:0 0005 000f 0000 0000 0000 0000 0000 0000 0000 0000
address 0 1 2 3 4 5 6 7 8 9
N11:0 0005 000f 0000 0000 0000 0000 0000 0000 0000 0000