Rockwell Automation 1203-SM1 SLC to SCANport Communication Module - Manual (Page 95)

SCANport Messaging B–29
Publication 1203–5.9 –– October 1996
The following error codes are possible:
If you get this
number:
Then:
0 No error occurred. The operation was successful.
1
The service failed. The SCANport device could
not perform this request.
2 Service not supported.
3 Class not supported.
4 Instance not supported.
5 Attribute not supported.
6 Value out of range.
7
SCANport device conflict –– cannot perform this
request while the SCANport device is in the
current state (usually while the drive is running).
0fdH (253)
Invalid message length. The message is too long
or too short to transmit.
0feH (254)
The message timed out before the response was
given. Check the SCANport connection.
Error Codes