Rockwell Automation 1203-SM1 SLC to SCANport Communication Module - Manual (Page 28)

3–10 Using Basic Mode
Publication 1203–5.9 –– October 1996
The following data table shows the input data read from the SLC to
SCANport module via the SLC backplane.
address 15 data 0
I:1 0000 0000 0000 0000 Drives 1 & 2 SCANport Channel Status
I:1.1 0000 0000 0000 0000 Drive 3 SCANport Channel Status
I:1.2 0000 0000 0000 0000 Drive 1 Logic Status
I:1.3 0000 0000 0000 0000 Drive 1 Feedback
I:1.4 0000 0000 0000 0000 Drive 2 Logic Status
I:1.5 0000 0000 0000 0000 Drive 2 Feedback
I:1.6 0000 0000 0000 0000 Drive 3 Logic Status
I:1.7 0000 0000 0000 0000 Drive 3 Feedback
The following data table shows the data to be sent to the SLC to
SCANport module via the SLC backplane.
address 15 data 0
O:1 0000 0000 0000 0000 Drives 1 & 2 SCANport Channel Enables
O:1.1 0000 0000 0000 0000 Drive 3 SCANport Channel Enable
O:1.2 0000 0000 0000 0000 Drive 1 Logic Command
O:1.3 0000 0000 0000 0000 Drive 1 Reference
O:1.4 0000 0000 0000 0000 Drive 2 Logic Command
O:1.5 0000 0000 0000 0000 Drive 2 Reference
O:1.6 0000 0000 0000 0000 Drive 1 Logic Command
O:1.7 0000 0000 0000 0000 Drive 1 Reference