Rockwell Automation 1747-SCNR SLC ControlNet Scanner Module Installation Instructions - Manual (Page 11)

SLC ControlNet Scanner Module 11
Publication 1747-IN059C-EN-P - September 2001
Remove the tap’s dust cap—located on the straight or right-angle
connector—and set it aside.
For detailed information about planning and installing your
ControlNet system, see the following information sources.
Connect Programming Terminal to ControlNet Network
You can connect the programming terminal to a ControlNet network
through a:
•
ControlNet product’s NAP using a network access cable
(1786-CP)
•
tap on a ControlNet network
If your network supports Connect the tap’s straight or right-angle connector
nonredundant media to the channel A connector on the scanner—channel
B is not used.
1
redundant media from trunk-cable A to channel A on the scanner and
from trunk-cable B to channel B on the scanner.
1. Rockwell Automation recommends using channel A for nonredundant media.
Source Source Number
ControlNet Coax Cable System Planning and Installation Manual 1786-6.2.1
ControlNet Media System Component List AG-2.2
ControlNet Coax Tap Installation Instructions 1786-5.7
ControlNet Network Access Cable Installation Instructions 1786-2.6
Industrial Automation Wiring and Grounding Guidelines 1770-4.1
Terminating Your ControlNet Coaxial Cables
CNET-DM001
1
1. The publication number listed includes only the base number. The Automation Bookstore and Manuals On
line will list the latest version of the publication. For example, CNET-DM001A-EN-P.
ATTENTION
ÿ
Use the 1786-CP cable when connecting a scanner to
the network through a NAP. Using a commercially
available RJ-style cable could result in network
failure.