Rockwell Automation 1747-PT1, D1747NP002 Hand-Held Terminal - Manual (Page 110)

Chapter 6
Creating a Program
6–12
3. Press [F1] , ENT. The display prompts you for the password:
File Name: 222 Prog Name:1000
File Name Type Size(Instr)
0 System *
1 Reserved *
2 222 Ladder *
F1 F2 F3 F4 F5
ENTER NEW PASSWORD: OFL
4. Type 123 . Notice that as you enter the characters, X ’s are displayed for
security reasons:
File Name: 222 Prog Name:1000
File Name Type Size(Instr)
0 System *
1 Reserved *
2 222 Ladder *
F1 F2 F3 F4 F5
ENTER NEW PASSWORD: XXX OFL
5. Press [ENTER] .
You are prompted to verify the password, by re–typing it:
File Name: 222 Prog Name:1000
File Name Type Size(Instr)
0 System *
1 Reserved *
2 222 Ladder *
F1 F2 F3 F4 F5
RE–ENTER NEW PASSWORD: OFL
6. Type 123 again. The password is now accepted.
7. Cycle power to the HHT for the password to take effect.
After the HHT powers up, you are requested to enter the password if you
press
[F3] , PROGMAINT or [F5] , UTILITY.
Entering Master Passwords
If a master password is required, press [F3] , ENT_MAS, from the password
menu display. The entry procedure is the same as for a password.