Rockwell Automation 1747-PT1, D1747NP002 Hand-Held Terminal - Manual (Page 140)

Chapter 7
Creating and Editing a Program File
7–28
5. Press [F5] , DEL_BR.
The following display cautions you that address references on this branch
remain in their last state (either energized or de–energized) when you
delete the instructions.
I
I I
I I
I
I I
F1 F2 F3 F4 F5
2.1.1.1.*
] [ ( )
] [
] [ ( )
] [
] [
]/[
] [
( )
DATA/FORCES IN LAST STATE,DELETE?
YES NO
OFL
Important: When you modify a program after leaving the Run mode, the
status bits associated with the instructions that are energized
(true) or forced on, remain in that state even after they are
deleted. This can cause incorrect program operation if these
addresses are associated with other instructions.
6. Press [F2] , YES to delete the branch. The display changes as follows:
I
I
I
I
I I
F1 F2 F3 F4 F5
2.1.1.1.*
] [ ( )
] [
] [ ( )
<
END
>
] [
]/[
OFL
EXT_UP EXT_DWN APP_BR DEL_BR INS_BR
( )
7. To remove the bottom branch level, press [
↓
] , then [F5] , DEL_BR.
8. Press [F2] , YES, then press [ESC] , to return to the previous display.
Press [F5] , ACP_RNG and save the changes.