Rockwell Automation 1791D-XXXX CompactBlock I/O for DeviceNet Modules Series D I.I. - Manual (Page 13)

CompactBlock I/O for DeviceNet Modules Series D 13
Publication 1791D-IN003A-EN-P - June 2003
1. Connect the DeviceNet cable (drop line) to the unsealed
DeviceNet terminal connector as shown below.
2. Connect the terminal connector to the Block. Use the side
screws on the terminal connector to fasten it to the Block.
IMPORTANT
DeviceNet cable connections must match the color
bars on the blocks. Refer to the table below.
Pin Number: Wire
Color: Abbreviation: Description:
1 black V- power return
2 blue CAN_L data line (CAN Low)
3 clear shield between cable jacket and wire
4 white CAN_H data line (CAN High)
5 red V+ positive voltage (hot)
30361