Rockwell Automation 1791D-XXXX CompactBlock I/O for DeviceNet Modules Series D I.I. - Manual (Page 4)

4 CompactBlock I/O for DeviceNet Modules Series D
Publication 1791D-IN003A-EN-P - June 2003
Installing CompactBlock I/O
Follow these steps, to install the 1791D I/O module:
1. Set the Node Address on the Base Module.
2. Mount the Block(s).
3. Connect the Input/Output Wires to the Block.
4. Connect the DeviceNet Cable.
5. Remove the terminal block.
6. Insert the terminal block.
7. Communicate with the 1791D Module.
These steps are explained in detail in the following
procedures.
ATTENTION
!
Preventing Electrostatic Discharge
This equipment is sensitive to electrostatic
discharge, which can cause internal damage and
affect normal operation. Follow these guidelines
when you handle this equipment:
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wriststrap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
• If available, use a static-safe workstation.
• When not in use, store the equipment in appropriate
static-safe packaging.