Rockwell Automation 1791D-XXXX CompactBlock I/O for DeviceNet Modules Series D I.I. User Manual
Page 6
Advertising
6 CompactBlock I/O for DeviceNet Modules Series D
Publication
1791D-IN003A-EN-P - June 2003
Base Module Mounting
You can install the CompactBlock base module on a panel or DIN
rail.
Panel Mounting
1. Place the module against the panel where you want to mount
it.
2. Drill holes in the panel that are aligned with mounting holes
on the module.
3. Place screws through each of the 2 mounting holes and
tighten the screws until the module is firmly in place.
!
WARNING
When used in a Class I, Division 2, hazardous
location, this equipment must be mounted in a
suitable enclosure with proper wiring method
that complies with the governing electrical
codes.
Base Module
141 mm
5.55 in
41 mm
1.6 in
41673
Advertising