Rockwell Automation 1791D-XXXX CompactBlock I/O for DeviceNet Modules Series D I.I. - Manual (Page 14)

14 CompactBlock I/O for DeviceNet Modules Series D
Publication 1791D-IN003A-EN-P - June 2003
Remove the Terminal Block
Follow the directions below to remove the CompactBlock terminal
block.
1. Unscrew the two retaining screws on the side of the terminal
block.
2. Lift the terminal block out of the base.
!
WARNING
When you connect or disconnect the Removable
Terminal Block (RTB) with field side power
applied, an electrical arc can occur. This could
cause an explosion in hazardous location
installations.
VDC
VDC
GND
GND
Not
Used
IN0
IN2
IN4
IN6
IN7
IN5
IN3
IN1
IN8
IN10
IN12
IN14
IN15
IN13
IN11
IN9
Retaining Screw
Retaining Screw
42979