Rockwell Automation 1792D-8BT8PE ArmorBlock MaXum 8 In/8 Out Module with Ground Lug - Manual (Page 6)

6 ArmorBlock MaXum 8 Input / 8 Output Module With Ground Lug
Publication 1792D-IN055A-EN-P - October 2004
To install the module:
1. Position the module over the mounted cable base. Align the
three captive screws in the module with the accepting
receptacles in the base.
2. Tighten the screws with a torque of 8 inch-pounds to secure
the module to the base.
Note: Dimensions change according to the cable base and
module combination used.
IMPORTANT
Proper alignment of the screws is necessary to
complete the connections between the module
contacts and the cable contacts.
WARNING
When used in a Class I, Division 2, hazardous
location, this equipment must be mounted in a
suitable enclosure with proper wiring method that
complies with the governing electrical codes.
Align the
screws to
properly
secure the
module to
the base.
Cable Base 1792D-CBFM
is used for this example.
1.9in. (48.26mm)
2.7in. (68.6mm)
6.85in. (174mm)
43875
Ground lug