Rockwell Automation 1771-P7 AC (120/220V) 16A Power Supply Installation Instructions - Manual (Page 8)

AC (120/220V) 16A Power Supply 8
Publication 1771ĆIN056B EN-P - December 2001
5. Attach the other end of the power cable to the D-shell connector
on the bottom of the power supply and tighten the connector
screws.
!
WARNING
If you connect or disconnect the power supply
cable with power applied an electrical arc can
occur. This could cause an explosion in hazardous
location installations. Be sure power is removed
or the area is nonhazardous before proceeding.
connector screws
DĆshell connector
1771ĆCP1 cable
1771ĆP7
left side I/O chassis
13449
Tighten connector screws
until snug, plus 1/4 turn).