Rockwell Automation 1790D-XXXX DeviceNet Digital Base D-Shell Module CompactBlock LDX I/O - Manual (Page 8)

8 DeviceNet Digital Base D-Shell Block CompactBlock LDX I/O
Publication 1790-IN007C-EN-P - May 2006
Mount the Base Block
Mount the base block to a panel or DIN rail.
We recommend that you ground the panel or DIN rail before
mounting the block.
Mount on a Panel
For panel mounting, use these steps.
1 . Place the block against the panel where you want it mounted.
2. Gently pull and position the expansion cover to the left.
3. Place a center punch, nail, or similar device through the
mounting holes in the block and make two marks on the
panel at the lower-left and upper-right corners of the module.
IMPORTANT
The analog base module can accommodate a maximum
of two digital expansion modules.
44153
41 mm
(1.6 in.)
Expansion
Cover
95 mm
(3.74 in.)