Rockwell Automation 1790D-XXXX DeviceNet Digital Base D-Shell Module CompactBlock LDX I/O - Manual (Page 9)

DeviceNet Digital Base D-Shell Block CompactBlock LDX I/O 9
Publication 1790-IN007C-EN-P - May 2006
4. Remove the block and drill two holes in the panel to
accommodate each of the mounting screws.
5. Replace the block on the panel and place a screw through
each of the two mounting holes.
6. Tighten the screws until the block is firmly in place.
Mount on DIN Rail
For DIN-rail mounting, use these steps.
1 . Hook the top slot of the base block over the DIN rail.
2. Pull down on the locking lever while pressing the base block
against the rail.
3. Push up on the locking lever to secure the base block to the
rail when the base block is flush against the rail.
Mount the Optional Expansion Block
Mount the expansion block by connecting it to a previously-installed
CompactBlock LDX I/O base or expansion block.
Locking Lever
44154