Rockwell Automation 1771-OFE Analog Output Module Installation Instructions - Manual

Publication 1771-IN044C-EN-P - October 2002
Analog Output Module
Catalog Number 1771ĆOFE Series B
Use this document as a guide when installing the 1771-OFE analog
output module.
To See page
Important User Information 1
Understand Product Compatibility 4
Calculate Power Requirements 4
Determine Module Placement 5
Set the Module Configuration Jumpers 5
Install the Keying Bands 8
Install the Module and Field Wiring Arm 9
Connect Wiring to the Field Wiring Arm 10
Ground the Chassis and Module 11
Configure the Module 12
For this reference information See page
Diagnostics and Troubleshooting 13
Hazardous Locations 15
Specifications 16
Because of the variety of uses for the products described in this
publication, those responsible for the application and use of these
products must satisfy themselves that all necessary steps have been
taken to assure that each application and use meets all performance
and safety requirements, including any applicable laws, regulations,
codes and standards. In no event will Rockwell Automation be
responsible or liable for indirect or consequential damage resulting
from the use or application of these products.
Any illustrations, charts, sample programs, and layout examples
shown in this publication are intended solely for purposes of
example. Since there are many variables and requirements associated
with any particular installation, Rockwell Automation does not
assume responsibility or liability (to include intellectual property
liability) for actual use based upon the examples shown in this
publication.
This icon is used when
additional information
is available in the Analog
Output Module User
Manual, publication
1771ĆUM030.
Installation Instructions
Contents
Important User
Information