Rockwell Automation 1784-U2DHP USB-to-Data Highway Plus Cable Installation Instructions User Manual
Page 10
10 USB-to-Data Highway Plus Cable
Rockwell Automation Publication 1784-IN045C-EN-P - May 2010
The Configure 1784-U2DHP dialog box appears.
5. Enter configuration information in each field.
6. Click OK.
In this field
Do this
Comm Port
Select the COM port you verified in
on
.
Station Number (node
address)
Enter the DH+ Station Number for this cable. The default is 0.
The 1784-U2DHP cable can use any DH+ network address from
0…77 octal.
The first packet sent from RSLinx Classic software to the
1784-U2DHP cable sets the DH+ network address the first time
that RSLinx Classic software communicates through the
1784-U2DHP cable after power is applied. See Configure the
DH+ Node Address on
.
IMPORTANT
Do not disconnect the cable without first using RSLinx Classic
software to stop the driver. Disconnecting the cable without
stopping the driver can shut down or cause RSLinx Classic
software to become unresponsive.