Rockwell Automation 1747-SDN 1747-SDN DeviceNet Scanner Installation Instructions - Manual (Page 11)

1747-SDN DeviceNet Scanner Module 11
Publication 1747-IN058F-EN-P - December 2010
2. Connect the DeviceNet drop line to the 10-pin linear plug by matching the wire
insulation colors to the colors shown on the label.
3. Locate the DeviceNet port connector on the front of the module.
4.
Insert the 10-pin linear plug into the DeviceNet port connector.
You have installed and wired your module. To operate the module you must apply power and
then configure and program the SLC processor to communicate with it.
WARNING
If you connect or disconnect the communications cable with power applied to
this module or any device on the network, an electrical arc can occur. This could
cause an explosion in hazardous location installations.
+24V Red
Can_H White
Drain/Shield
Can_L Blue
+24V Return Black
Front of Module
10-pin linear
plug Red
White
Shield
Blue
Black
10-pin Linear plug
DeviceNet drop line
DeviceNet port
connector