Rockwell Automation 1788-CN2FF ControlNet-to-FOUNDATION Fieldbus H1 Linking Device User Manual - Manual (Page 11)

1788-6.5.1 - January 1999
Chapter
2
Hardware Installation and Configuration
Handling the Linking Device We recommend that you adhere to this precautionary information.
Installing the Linking Device The linking device has a rugged, simple clip for mounting reliably on a
standard 35 mm DIN rail. Follow these steps to mount the linking device
onto a DIN rail.
1. Use a flat-bladed screwdriver to open the DIN rail clip to the unlocked
position.
2. Hook the lip on the rear of the linking device onto the top of a 35 mm
DIN rail and press the linking device down onto the DIN rail.
!
ATTENTION: This module contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing or testing this
assembly. Component damage may result if these procedures
are not followed.
Rail Clip Locked Rail Clip Unlocked
Cover
Press
DIN Rail