Connecting to the fieldbus network – Rockwell Automation 1788-CN2FF ControlNet-to-FOUNDATION Fieldbus H1 Linking Device User Manual User Manual
Page 14
Advertising
1788-6.5.1 - January 1999
2-4
Hardware Installation and Configuration
Connecting to
the Fieldbus Network
The location of the Fieldbus connectors is shown in Figure 2.3.
Figure 2.3 Fieldbus Connectors on the Linking Device
If you want to make your own Fieldbus cable, make sure that it uses
pins 6 and 7 for the Fieldbus signals, as specified in the
Fieldbus Standard
for Use in Industrial Control Systems, Part 2, ISA-S50.02.1992. Refer to
Figure 2.4 for the connector pinout of the linking device.
Figure 2.4 Fieldbus Connector Pinout for the Linking Device
Fieldbus Connectors
1
2
3
4
5
6
7
8
9
NC
NC
NC
NC
NC
NC
NC
Data +
Data –
NC = No Connection
Advertising