Rockwell Automation 1788-CN2FF ControlNet-to-FOUNDATION Fieldbus H1 Linking Device User Manual - Manual (Page 12)

1788-6.5.1 - January 1999
2-2 Hardware Installation and Configuration
3. Slide the linking device to the desired position on the DIN rail. After it is
in position, push the rail snap into the locked position to lock it in place
on the DIN rail.
Removing the Linking Device To remove a linking device, unlock it from the DIN rail by placing a
screwdriver in the slot on the rail snap and opening the rail snap to the
unlocked position as shown in step 1 on page 2-1. Then lift the device off of
the rail.
Connecting Power An 11-30V dc power supply is required by each linking device. The linking
device filters and regulates this supplied power. The power connector is a
6-pin screw terminal connector. The pinout for the power connector is
shown in Figure 2.1.
Figure 2.1 Power Connector Pinout
Rail Clip Locked Rail Clip Unlocked
(Position Device Along DIN Rail)
DIN Rail
Linking
Device
v
v
v
c c
c
11-30 VDC
Backup Power
Supply
(optional)
+
–
+
–
11-30 VDC
Primary Power
Supply
V
C
To adjacent device
(optional connection)