Rockwell Automation 1785-Lx0E,D178510.5 QUICK START ETHERNET PLC-9 - Manual (Page 16)

Publication 1785-10.5 - November 1998
2-6 Set up the Hardware
Power Up the System
Power up the system. Check the LED display on the processor. If
your system is operating properly, the PROC LED should be steady
red. If the PROC LED is not red, see chapter 4 for troubleshooting
information before you install any I/O modules.
Install the I/O Modules
For more information, see the installation instructions or user manual
for the particular module you are installing.
Connect the Personal
Computer to the
PLC-5 Processor For more information, see:
• Enhanced and Ethernet PLC-5 Programmable Controller User
Manual, publication number 1785-6.5.12
• the documentation provided with your communication card
• Data Highway/Data Highway Plus/Data Highway II/Data
Highway 485 Cable Installation Manual, publication 1770-6.2.2
Locking
Bar
Card Guides
20618-M
Install each I/O module and connect
the wiring arm.