Rockwell Automation 1769-OF4 Compact I/O Analog Output Module - Manual (Page 12)

12
Compact I/O Analog Output Module
Publication 1769-IN087A-EN-P - August 2009
Wire Analog Outputs
Label the Terminals
A removable, write-on label is provided with the module. Remove the label from
the door, mark the identification of each terminal with permanent ink, and slide the
label back into the door. Your markings (ID tag) will be visible when the module
door is closed.
Remove the Finger-safe Terminal Block
When wiring field devices to the module, it is not necessary to remove the terminal
block. If you remove the terminal block, use the write-on label on the side of the
terminal block to identify the module slot location and type.
ATTENTION
Analog outputs may fluctuate for less than a second when power is applied
or removed. This characteristic is common to most analog outputs. While
the majority of loads will not recognize this short signal, take preventive
measures to make sure that connected equipment is not affected. Failure
to take these preventative measures may result in unexpected load
reactions.
V out 3+
ANLG Com
ANLG Com
I out 3+
I out 0+
V out 0+
I out 1 +
V out 1+
I out 2+
V out 2+
Voltage Load
Current Load
Earth Ground
Earth Ground
1769-OF4 Terminal Block
SLOT # ____
MODULE TYPE _____
R L
RoHS