Rockwell Automation 1769-OF4 Compact I/O Analog Output Module - Manual (Page 8)

8
Compact I/O Analog Output Module
Publication 1769-IN087A-EN-P - August 2009
5. Gently slide the disconnected module forward.
If you feel excessive resistance, check that the module is disconnected from
the bus and that both mounting screws are removed or DIN latches opened.
6. Be sure that the bus lever on the module and on the right-side adjacent
module are in the unlocked (fully right) position before installing the
replacement module.
7. Slide the replacement module into the open slot.
8. Connect the modules by locking (fully left) the bus levers on the
replacement module and the right-side adjacent module.
9. Replace the mounting screws or snap the module onto the DIN rail.
Mount Expansion I/O
Minimum Spacing
Maintain spacing from enclosure walls, wireways, or adjacent equipment. Allow
50 mm (2 in.) of space on all sides for adequate ventilation, as shown.
TIP
It may be necessary to rock the module slightly from front to back to remove it,
or, in a panel-mounted system, to loosen the screws of adjacent modules.
ATTENTION
During panel or DIN rail mounting of all devices, be sure that all debris, that is,
metal chips or wire strands, is kept from falling into the module. Debris that
falls into the module could cause damage when cycling power.
Controller
Bottom
Side Side
Top
Com
pa
ct
I/O
Com
pa
ct
I/O
Com
pa
ct
I/O
Com
pa
ct
I/O
End Cap
Com
pa
ct
I/O