Rockwell Automation 1786-TPYS ControlNet Coax Taps Installation Instructions - Manual (Page 11)

ControlNet Coax Taps 11
Rockwell Automation Publication 1786-IN007C-EN-P - October 2010
Mount Through Holes in Tap
To mount the tap by using the holes in the tap body, choose one of the following
mounting methods:
• Thread tie wrap through the holes in the tap and fasten to a fixture.
• Insert two #8 or smaller screws with washers (not included) through the
holes and tighten into the surface behind the tap
IMPORTANT Do not over-tighten screws as tap body damage may result.
Applied screw torque should not exceed 0.2…0.4 N
• m
(0.14…0.29 lb • ft).