Additional parts (not included) – Rockwell Automation 1786-TPYS ControlNet Coax Taps Installation Instructions User Manual
Page 5
ControlNet Coax Taps 5
Rockwell Automation Publication 1786-IN007C-EN-P - October 2010
Additional Parts (not included)
Depending on the type of tap mount and installation you choose, you may
require additional parts not included with this tap kit. This list describes
additional parts that may be required for your tap installation.
•
DIN rail, 35 x 7.5 mm (1.38 x .30 in.), EN 50022-35 x 7.5
•
DIN rail, 35 x 15 mm (1.38 x .59 in.), EN 50022-35 x 15
•
Screws of various lengths
•
Tie wrap (for mounting the tap)
•
12.7 mm (0.50 in.) diameter max hook-and-loop
wire strap for securing coax cable (including tap
cable)
IMPORTANT
The ControlNet taps do not require the use of DIN rails made of specific
materials. However, many of other products available from Rockwell
Automation do require the use of a zinc-plated yellow-chromate steel DIN
rail to assure proper grounding. The use of other DIN rail materials (such
as aluminum or plastic) that can corrode, oxidize, or are poor conductors,
can result in improper or intermittent grounding.
For compatibility with other Rockwell Automation products, we
recommend that you use the zinc-plated yellow-chromate steel DIN rail.