Rockwell Automation 1763-L16xxx MicroLogix 1100 Programmable Controllers Installation Instructions - Manual (Page 12)

12
Publication 1763-IN001B-EN-P - September 2007
Follow these steps to install your controller on the DIN rail.
1. Mount your DIN rail. (Make sure that the placement of the controller on the
DIN rail meets the recommended spacing requirements. See Controller
Spacing on page 11. Refer to the mounting template inside the back cover of
this document.)
2. If it is open, close the DIN latch.
3. Hook the top slot over the DIN rail.
4. While pressing the controller down against the top of the rail, snap the
bottom of the controller into position.
5. Leave the protective debris strip attached until you are finished wiring the
controller and any other devices.
Follow these steps to remove your controller from the DIN rail.
1. Place a flat-blade screwdriver in the DIN rail latch at the bottom of the
controller.
2. Holding the controller, pry downward on the latch until the latch locks in
the open position.
3. Repeat steps 1 and 2 for the second DIN rail latch.
4. Unhook the top of the DIN rail slot from the rail.
ESC OK
open
closed