Rockwell Automation 2706-P92C_P94C InView Message Display - Manual (Page 16)

16 InView Marquee Message Display
Publication 2706-IN016D-EN-P - February 2009
Follow these steps to replace the battery in the InView 2706-P92C or 2706-P94C
message displays.
1. Disconnect power from the message display.
2. Turn the half-turn latches all the way to the left until they hit the stop.
3. Carefully lower the door.
4. Locate the battery on the circuit board.
5. Press down firmly on the middle part of battery retainer clip.
The battery will pop out.
6. Slide the new battery under the 3-prong holder and push down.
7. Raise the door and turn the half-turn latches all the way right until they hit
the stop and the door is pulled in.
Half-turn Latches on an 2706-P94C Sign
Front View,
closed
Front View, open
Circuit
Board
Press down here to pop battery out.
Battery