Rockwell Automation 2706-P92C_P94C InView Message Display - Manual (Page 7)

InView Marquee Message Display 7
Publication 2706-IN016D-EN-P - February 2009
3. Tilt the sign to select a viewing angle. To hold the sign in place, inset the
remaining bolts into the desired viewing angle hole on each bracket.
Back-to-back Mounting
1. Attach the brackets to the sign in the ceiling mount position. Use the hex
bolts supplied.
2. Match the signs together back-to-back. Connect them together using a total
of six 5/16” bolts and nuts (not supplied).
3. Use chains (not supplied) to hang the signs from the ceiling. Attach the
chains to the top mounting holes of the bracket.
TIP
Keep a minimum 2.54 cm (1.0 in.) clearance on all sides of the sign for adequate
ventilation.
TIP
Use chains capable of supporting 4 times the total weight of the signs.
Desired Viewing
Angle Hole
Wall
Ceiling
End View,
Wall/Ceiling
Mounted
Second
Sign
First
Sign
Second
Mounting
Bracket
First
Mounting
Bracket
Attach chains here