Rockwell Automation 2711PC-T10C4D1 PanelView Plus Terminals and Display Modules - Manual (Page 13)

PanelView Plus 700 to 1500 and PanelView Plus Compact 1000 Terminals and Display Modules 13
Publication 2711P-IN001I-EN-P - November 2009
7. Tighten the mounting clip screws to a torque of 0.90…1.1 N•m
(8…10 lb•in) by using the specified torque sequence, making sure not to overtighten.
Product Dimensions
The table provides product dimensions for the terminals including depth dimensions for the:
•
base configured unit (display module and logic module).
•
base configured unit with communication module.
ATTENTION
Tighten the mounting clips to the specified torque to provide a proper seal and prevent
damage to the product. Rockwell Automation assumes no responsibility for water or
chemical damage to the product or other equipment within the enclosure because of
improper installation.
Terminal Type
Height,
Approx.,
mm (in.)
Width,
Approx.,
mm (in.)
Depth, Approx., mm (in.)
700 Keypad or Keypad and Touch 193 (7.58) 290 (11.40) 55 (2.18)
display to logic module
83 (3.27)
display to comm module
700 Touch Screen 179 (7.04) 246 (9.68)
1000 Keypad or Keypad and Touch 248 (9.77) 399 (15.72)
1000 Touch Screen 248 (9.77) 329 (12.97)
1250 Keypad or Keypad and Touch 282 (11.12) 416 (16.36)
1250 Touch Screen 282 (11.12) 363 (14.30)
1500 Keypad or Keypad and Touch 330 (12.97) 469 (18.46) 65 (2.55)
display to logic module
93 (3.65)
display to comm module
1500 Touch Screen 330 (12.97) 416 (16.36)
8 Clips
6 Clips
4 Clips
1 4
3 2
1 3 5
4 6 2
1 6
5 2
3
7
8
4