Rockwell Automation 2711 PanelView 1400 Terminals Installation Instructions - Manual (Page 10)

PanelView 1400 Terminals 9
6. Alternately tighten the mounting clip screws until the terminal is held firmly
against the panel. Tighten mounting screws to a torque of 10 inch-pounds.
Do not over-tighten.
!
ATTENTION: Tighten mounting clips to a torque of 10
inch-pounds (1.1 N Sm
) to provide a proper seal and to prevent
potential damage to the terminal. Allen-Bradley assumes no
responsibility for water or chemical damage to the terminal or
other equipment within the enclosure because of improper
installation.
To install the PV1400 terminal in a panel using mounting studs:
1. Cut an opening in the panel using the panel cutout shipped with the terminal.
Carefully drill 5.6 mm (7/32 inch) holes for studs as indicated.
2. Install the mounting studs (Catalog No. 2711-NP3) using a 7/32 inch socket
on the end of the stud. Turn stud clockwise to tighten approximately 10
inch-pounds (1.1
N
Sm).
Mounting Studs
(Qty 18 for Keypad
Qty 12 for Touch)
Bezel
Gasket
Spacer
Self-Locking Nuts
Panel or Enclosure
!
ATTENTION: Be careful not to damage the sealing gasket
when installing or removing the studs. A damaged seal may
result in damage to the terminal and other panel components due
to a leaking seal.