Rockwell Automation 2711 PanelView 1400 Terminals Installation Instructions - Manual (Page 4)

PanelView 1400 Terminals 3
Recommended Tools
In addition to the tools required for the panel cutout, you need the tools
listed below.
For clip mounting:
•
socket screw driver (phillips head or slotted)
•
16 inch (406 mm) extension rod (minimum)
•
socket driver (in/lb) torque wrench recommended
For stud mounting:
•
7/32 and 3/8 inch socket
•
16 inch (406 mm) extension rod (minimum)
•
socket driver (in/lb) torque wrench recommended
Enclosures
The PanelView 1400 terminal must be mounted in an environment that provides
IEC-1131-2 Pollution degree 2 protection.
Mount the terminal in a panel or enclosure to protect the internal circuitry. The
terminal meets NEMA Type 12/13 and 4X (indoor use) ratings only when
mounted in a panel or enclosure with the equivalent rating.
Allow enough space within the enclosure for adequate ventilation. Consider the
heat produced by other devices in the enclosure. The ambient temperature around
the terminal must be between 0
_ and 55_C (32_ and 131_F).
Make provisions for accessing the back sides of the terminal. Access is required
for wiring, maintenance, adjusting brightness/contrast, installing a memory card,
and troubleshooting.