Rockwell Automation 2711 PanelView 1400 Terminals Installation Instructions - Manual (Page 11)

PanelView 1400 Terminals 10
3. Make sure the sealing gasket is properly positioned on the terminal. This
gasket forms a compression type seal (NEMA Type 4). Do not use sealing
compounds.
4. Place the terminal in the panel cutout aligning the studs with the mounting
holes.
5. Install the self-locking nuts hand-tight.
!
ATTENTION: Tighten mounting nuts to a torque of 10
inch-pounds (1.1 N Sm
) to provide a proper seal and prevent
damage to the terminal. Allen-Bradley assumes no responsibility
for water or chemical damage to the terminal or other equipment
within the enclosure because of improper installation.
6. Alternately tighten the self-locking nuts (use 3/8 inch socket) until the
terminal is held firmly against the panel. (The recommended tightening
sequence is shown below.)
The studs have an integral spacer that prevents the gasket from being
over-compressed. The amount of torque required increases significantly as the
gasket reaches the proper compression. Tighten nuts to a torque 10 inch-pounds
(1.1
N
Sm).
1
2
3 4
5
6
7 8
9
10
11 12
13
14
15 16
17
18
Recommended
Torque Sequence
for Keypad Terminals
Note that sequence starts at center studs and continues to the corner studs.
1
2
8 7
5
6
4 3
9
10
11 12
Recommended
Torque Sequence
for Touch Terminals