Rockwell Automation 2711 PanelView 1400 Terminals Installation Instructions - Manual (Page 9)

PanelView 1400 Terminals 8
3. Although the keypad legend strips can be installed at any time, we
recommend that you install them after the terminal is installed.
4. Place the terminal in the panel cutout. The terminal will snap into the panel
as the temporary retaining tabs lock against the panel.
Note: The terminal has 2 metal tabs (on bottom edge) that temporarily lock the
terminal against the panel. These tabs only facilitate installation of the mounting
hardware. The tabs are not designed to provide permanent mounting.
5. Install the 10 mounting clips (3 on top, 3 on bottom, 2 on each side); the ends
of the clips slide into the slots on the terminal. Tighten the clip mounting
screws hand tight.
Figure 6
Mounting Clips
Install 10 Mounting Clips:
Keypad Versions
Touch Screen Versions
= Recommended Placement
of Mounting Clips