Powerup sequence, Powerup sequence (dip switch sw-1 on) – Rockwell Automation 2707-L8PxX, -L40PxX, -V40PxX DTAM Plus Operator Interface Installation Instructions User Manual

Page 10

Advertising

The powerup sequence is automatic. The sequence depends upon the
setting of DIP switch position SW-1 (upload / download enable).
The DTAM Plus is shipped with SW-1 On.

Powerup Sequence (DIP Switch SW-1 ON)

The following steps show the powerup sequence if DIP switch SW-1
is ON.

1. The DTAM Plus verifies the system memory checksum, program

checksum, and system RAM. When done, the result is displayed
with the current DIP switch settings.

Memory Check: pass

DIP Switch: 101000
40K User Memory

2. The display is tested, every pixel of the display is turned on.

ОО

Use this display to verify that all pixels are operational.

3. The firmware version number and type of communication port(s)

is displayed (PPort, RS-232, RS-485 or Remote I/O).

Operator Interface
Core: X.XX RS-485
PPORT

4. The DTAM Plus waits for an application download.

Programming Mode

Waiting Up/Download

You cannot operate the DTAM Plus keypad while in the
upload/download mode. The DTAM Plus is waiting for
upload/download operations with a personal computer running
the DTAM Programming Software (DPS).

Powerup Sequence

Advertising

Popular Brands

Popular manuals