Rockwell Automation 2707-L8PxX, -L40PxX, -V40PxX DTAM Plus Operator Interface Installation Instructions - Manual (Page 16)

16
4. Make sure that the communication parameters of the DTAM Plus
terminal match the host device.
5. Apply power and verify that communications are established.
To connect the DTAM Plus terminal to Remote I/O:
1. Make sure that the power to the DTAM Plus is off.
2. The Remote I/O port of the DTAM Plus provides access via a
Remote I/O link directly to a controller or subscanner. Use cable
(Catalog No. 1770–CD) Belden 9463 for all Remote I/O
connections. Refer to Publication 1770–4.1 for detailed grounding
and wiring guidelines. The User Manual for your controller or
subscanner will also provide cabling instructions.
3. Make sure that the communication parameters of the DTAM Plus
terminal match the host device.
4. Apply power and verify that communications are established.