Rockwell Automation 6186-Mxxx Industrial Monitors Installation Instructions - Manual (Page 11)

Industrial Monitors 11
Publication 6186M-IN001L-EN-P - July 2008
Mount the Monitor in a Panel
Follow these directions to mount the monitor in a panel.
1. Cut the panel opening by using the appropriate cutout dimensions.
2. Attach the cables to the monitor if access to the rear of the monitor will not
be possible after the installation.
Refer to Monitor Connections on page 19.
3. Verify that the sealing gasket is properly positioned on the monitor.
This gasket forms a compression-type seal. Do not use sealing compounds.
4. Place the monitor in the panel cutout.
5. Slide the mounting clips into the slots on the top, bottom, and sides of the
monitor.