Rockwell Automation 6186-Mxxx Industrial Monitors Installation Instructions - Manual (Page 23)

Industrial Monitors 23
Publication 6186M-IN001L-EN-P - July 2008
Connect DC Power
The monitors connect to a DC power source using a DC input terminal block.
Follow these steps to connect power to the monitor.
1. Turn off the main power switch or breaker.
2. Route the power wires from your DC power supply and connect the leads to
the DC input terminal block on the monitor.
The monitors accept a 9…36V DC input power-supply connection.
3. Tighten the screw terminals to provide a good connection.
4. Secure the terminal block connector to the unit by using the two side
screws.
5. Restore DC power.
ATTENTION
Connect the product to earth ground using a 1.31 mm 2 (16 AWG) or larger
external wire. The ground wire should have green insulation with a yellow
stripe for easy identification.
+9V…+36 Gnd
To
Source