Rockwell Automation 6186-Mxxx Industrial Monitors Installation Instructions - Manual (Page 14)

14 Industrial Monitors
Publication 6186M-IN001L-EN-P - July 2008
Bench or Tabletop Mounting
Use the optional bench/tabletop adapter for monitors, catalog number 6189V-MBA,
to mount your monitor on a bench or tabletop arm.
Mounting Guidelines
Observe these guidelines when installing the monitor on an arm.
•
The mounting surface and the mounting arm must be strong enough to
support both the monitor and the mounting hardware.
•
The interface between the arm and the monitor must meet VESA FPMPMI
100 mm (3.94 in.) standards.
•
The mounting location must provide adequate clearance for positioning and
moving the adjustable unit, and routing cables.
Mounting the Monitor on a Bench or Tabletop
Follow these directions to mount the monitor to a bench or tabletop.
1. Mount the arm to the bench or tabletop by using screws, bolts, or clamps so
the monitor cannot tip.
2. Place the monitor over the arm and insert four M4 x 0.7 screws through the
arm brackets and into the monitor.
The illustration shows the mounting holes for VESA FPMPMI standard
100 mm (3.94 in.) interface pad.
3. Tighten the screws.